Junction & Inspection Point Relining in Sydney
Junction and inspection point relining in Sydney: every time the camera goes down, the root mass sits where the bathroom branch meets the main line.
Tell us what's happening
The short answer
Junction relining seals the joint where a branch meets the main line with a liner, so roots stop coming back without digging up the whole run.
What happens when you get in touch
Step 1: Call or book online
Tell us what is happening. We ask the right questions and book a time that suits you.
Step 2: We find the cause
A licensed plumber diagnoses it properly, with a drain camera, leak detection or a pressure test where it helps.
Step 3: A fixed price, agreed first
You agree the price before any work starts. We quote the job, not the hour, so there are no surprise charges.
Step 4: Done right, guaranteed
We finish the job, clean up, and back our workmanship with a lifetime labour guarantee.
Step 5: You know the price first
The figure for the whole job, in writing, before anyone starts. That figure is what turns up on the invoice.
Rated 4.9 from 237 reviews
Questions and answers
Yes, and when the rest of the run films clean, that is the right job. It is a much smaller job than a full liner. We only quote the whole line when the footage shows the whole line needs it.
It has more seams than anywhere else on the line and the two pipes move independently, so it is the first place to leak. Roots follow that moisture and get in through the first gap they find.
Sydney Water owns the junction on its main, but you are responsible for your point of connection and for clearing roots that get into the junction there. Root damage to the junction is also the owner's to fix.
If their relining contractor did not reopen your live junction, Sydney Water arranges for the contractor to come back and reopen it. Our camera can show whether that is what happened.
The number of junctions, their size and angle, how far into the line they sit and how much root has to come out set the price. We film first and put the figure in writing before we start.
A single junction is normally one visit, including the clean, the liner, the cure and the final film. You lose the fixtures on that line only while the resin cures.
Ready to get started?
Call us now, or send the form and we will come back to you.
Open 24/7