Gas Hot Water Repair in Sydney
Gas hot water repair in Sydney: you got thirty seconds of warm water and then the shower turned cold, which on a gas unit points at the pilot, the thermocouple or the gas valve behind it.
Tell us what's happening
The short answer
Gas hot water repair in Sydney: we test the pilot, thermocouple and gas valve before a spanner comes out, then give you the price in writing.
How it works
Step 1: Call or book online
Tell us what is happening. We ask the right questions and book a time that suits you.
Step 2: We find the cause
A licensed plumber diagnoses it properly, with a drain camera, leak detection or a pressure test where it helps.
Step 3: A fixed price, agreed first
You agree the price before any work starts. We quote the job, not the hour, so there are no surprise charges.
Step 4: Done right, guaranteed
We finish the job, clean up, and back our workmanship with a lifetime labour guarantee.
Step 5: You know the price first
The figure for the whole job, in writing, before anyone starts. That figure is what turns up on the invoice.
Rated 4.9 from 237 reviews
Questions and answers
On a storage unit that pattern usually points at the thermocouple or a thermostat that has drifted, so the burner stops firing while warm water still sits in the top of the tank. On a continuous-flow unit the controller shows a code, and the code names the part before anything is opened up.
You get the number in writing once the unit has been tested, and there's a $0 call-out on any job you book with us. If the tank has rusted through, we price the replacement instead of selling you a part that can't hold.
A worn thermocouple is the usual reason. A dirty or partly blocked pilot, a draught across an exposed wall or a faulty gas valve can do the same, and we test for each so you're not paying for guesses.
We'd rather you didn't. A pilot that has gone out has usually gone out for a reason, and relighting it on a failing thermocouple or a blocked flue only hides the problem. Tell us what you can see through the window and we'll handle the gas side.
Write it down and read it to us on the phone. Codes point at ignition, flame, water flow or overheating, which tells us what to bring. If the code keeps coming back, the unit needs a proper look rather than another reset.
It's the licensed gasfitter's record that the gas work on your heater was done to standard, with their name and licence number on it. NSW requires one after any gas work, so keep it with your house papers.
Tell us about your job
Call us now, or send the form and we will come back to you.
Open 24/7