Electric Hot Water Repair in Sydney
Electric hot water repair in Sydney: four minutes of hot water instead of fifteen on an electric storage tank points at the lower element failing while the top one heats the last third.
Tell us what's happening

The short answer
Electric hot water repair in Sydney: we isolate the fault, test the element and thermostat, and write the price down before any work starts.
What happens when you get in touch
Step 1: Call or book online
Tell us what is happening. We ask the right questions and book a time that suits you.
Step 2: We find the cause
A licensed plumber diagnoses it properly, with a drain camera, leak detection or a pressure test where it helps.
Step 3: A fixed price, agreed first
You agree the price before any work starts. We quote the job, not the hour, so there are no surprise charges.
Step 4: Done right, guaranteed
We finish the job, clean up, and back our workmanship with a lifetime labour guarantee.
Step 5: You know the price first
The figure for the whole job, in writing, before anyone starts. That figure is what turns up on the invoice.
Rated 4.9 from 237 reviews
Questions and answers
The circuit usually answers it: an element gone to earth trips the safety switch, while a drifted thermostat leaves the water lukewarm and trips nothing. We test both, because a failing element often cooks the thermostat on its way out.
Draining the tank is the slow part, so most element swaps run a couple of hours from the truck to the first hot shower, plus the time the tank takes to heat. The common elements are on board, so it's one visit.
The usual suspects are a tripped circuit, a failed element, a thermostat stuck off, a tripped over-temperature cut-out, or an off-peak control that has stopped switching. Check the board once, then ring us with what you found.
On a twin-element tank it's often the bottom element. It can also be a tank that's too small for the household, a tempering valve out of adjustment, or an off-peak tank that simply hasn't had its overnight heat yet.
Either the heater has a fault or the power isn't reaching it during the off-peak hours. We test at the heater terminals so you know which side the problem is on before anyone buys parts.
Yes. We service Rinnai, Rheem, Bosch, Dux, Aquamax and Vulcan, and Dux, Rheem and Aquamax elements are carried on the truck.
Tell us about your job
Call us now, or send the form and we will come back to you.
Open 24/7
