Kitchen Sink & Waste Installation in Sydney
Kitchen sink and waste installation in Sydney: we take out the old sink, connect the new one and rework the waste underneath.
Tell us what's happening
The short answer
The new sink is sitting in its box on the benchtop and the old one is still in the hole, along with a tangle of hoses nobody has touched in fifteen years. Here's how the swap goes.
How it works
Step 1: Call or book online
Tell us what is happening. We ask the right questions and book a time that suits you.
Step 2: We find the cause
A licensed plumber diagnoses it properly, with a drain camera, leak detection or a pressure test where it helps.
Step 3: A fixed price, agreed first
You agree the price before any work starts. We quote the job, not the hour, so there are no surprise charges.
Step 4: Done right, guaranteed
We finish the job, clean up, and back our workmanship with a lifetime labour guarantee.
Step 5: You know the price first
The figure for the whole job, in writing, before anyone starts. That figure is what turns up on the invoice.
Rated 4.9 from 237 reviews
Questions and answers
Send us the model number and a photo of the cupboard underneath and we'll check the cut-out dimensions against what you have. Undermount and topmount sinks sit differently on a stone benchtop, so that's worth knowing before install day.
The trap is either sitting too low or has too many bends squeezed into a small cupboard, so air gets pulled through the water seal. Reworking that run is a short job, and it stops the noise.
Yes for topmount sinks: they sit on fresh sealant and are clamped down with the clips supplied. Undermount sinks on stone are usually fixed by the stonemason, and we connect everything underneath.
It depends on whether the new sink fits the existing hole, the benchtop material and how much is going under the sink. You'll have the price in writing before the old sink lifts.
Usually, if the new sink fits the existing cut-out or the hole can be made bigger. A stone cut-out can be enlarged by a stonemason, but a hole can never be made smaller.
If it's more than a few years old, it's worth considering. It's far easier to fit a mixer to a sink on the bench than to change one later from inside the cupboard.
Tell us about your job
Call us now, or send the form and we will come back to you.
Open 24/7